Portable Air Scrubber - Revision history

51.175.10.161: Add two sentences about gas release upon deconstruction

2026-02-07T07:58:27Z

Add two sentences about gas release upon deconstruction

Viperel at 11:37, 7 August 2018

2018-08-07T11:37:19Z

Viperel at 09:13, 2 August 2018

2018-08-02T09:13:19Z

Viperel: updated info

2018-08-02T09:12:42Z

updated info

Viperel: as found in world.xml

2018-01-08T07:02:56Z

as found in world.xml

Tofof: /* Notes */ holds same volume as the much-larger-appearing portable tank

2018-01-07T20:17:06Z

‎Notes: holds same volume as the much-larger-appearing portable tank

Tofof: volume infobox

2018-01-07T20:12:18Z

volume infobox

Viperel at 11:39, 7 January 2018

2018-01-07T11:39:33Z

Viperel at 11:30, 7 January 2018

2018-01-07T11:30:00Z

Viperel: fixed

2018-01-07T11:24:35Z

fixed

@@ Line 10: / Line 10: @@
 }}
 ==Description==
-Used as a portable Filtration Unit. The filters placed in the back will determine what is being absorbed from the air. The device will flash an error after it reaches an internal pressure of 8106 kPa and will require to be emptied. To do so you can pull the lever on the side to evacuate the air inside, or place it over a [[Tank Connector]] and lock into position by using a [[Wrench]] to transfer the gasses stored inside into the pipe network directly.
+Used as a portable Filtration Unit. The filters placed in the back will determine what is being absorbed from the air. The device will flash an error after it reaches an internal pressure of 8106 kPa and will require to be emptied. To do so you can pull the lever on the side to evacuate the air inside, or place it over a [[Tank Connector]] and lock into position by using a [[Wrench]] to transfer the gasses stored inside into the pipe network directly. Upon deconstruction its stored gas will be released, depending on the content and pressure, this can have explosive results if done inside.
 ==Notes==

@@ Line 14: / Line 14: @@
 ==Notes==
 * Internal tank volume is 250 Liters.
-* The power usage is 37.5W/tick meaning a Small Battery will last 8 minutes.
+* The power usage is 20.5W/tick meaning a Small Battery will last 14 minutes and 38 seconds.
 * It will add heat by a rate of 12.5J/s while powered.
 * You can insert two filters of the same type to double the speed.

@@ Line 10: / Line 10: @@
 }}
 ==Description==
-Used as a portable Filtration Unit. The filters placed in the back will determine what is being absorbed from the air. The device will flash an error after it reaches an internal pressure of 8106 kPa and will require to be emptied. To do so you can pull the lever on the side to evacuate the air inside, or place it over a [[Tank Connector]] and lock into position by using a [[Wrench]]to passing all the gasses inside into the pipe network directly.
+Used as a portable Filtration Unit. The filters placed in the back will determine what is being absorbed from the air. The device will flash an error after it reaches an internal pressure of 8106 kPa and will require to be emptied. To do so you can pull the lever on the side to evacuate the air inside, or place it over a [[Tank Connector]] and lock into position by using a [[Wrench]] to transfer the gasses stored inside into the pipe network directly.
 ==Notes==

@@ Line 6: / Line 6: @@
   | maxpressure = 8106 kPa
   | volume      = 250 L
-  | createdwith = [[Hydraulic Pipe Bender]]
+  | createdwith = [[Hydraulic Pipe Bender]], [[Fabricator]]
-  | cost        = 10g [[Iron]], 2g [[Gold]], 5g [[Copper]]
+  | cost        = 20g [[Steel Ingot]], 5g [[Gold Ingot]], 5g [[Invar Ingot]], 5g [[Solder Ingot]]
 }}
 ==Description==
-Used as a portable Filtration Unit. The filters placed in the back will determine what is being absorbed from the air. The device will flash an error after it reaches an internal pressure of 8106 kPa and will require to be emptied. To do so it needs to be placed over a [[Tank Connector]] and lock into position by using a [[Wrench]]. Then it will start passing all the gasses inside into the network directly.
+Used as a portable Filtration Unit. The filters placed in the back will determine what is being absorbed from the air. The device will flash an error after it reaches an internal pressure of 8106 kPa and will require to be emptied. To do so you can pull the lever on the side to evacuate the air inside, or place it over a [[Tank Connector]] and lock into position by using a [[Wrench]]to passing all the gasses inside into the pipe network directly.
 ==Notes==
 * Internal tank volume is 250 Liters.
-* The power usage is 37.5W/s meaning a Small Battery will last 16 minutes.
+* The power usage is 37.5W/tick meaning a Small Battery will last 8 minutes.
 * It will add heat by a rate of 12.5J/s while powered.
 * You can insert two filters of the same type to double the speed.

@@ Line 5: / Line 5: @@
   | image       = [[File:DynamicScrubber.png]]
   | maxpressure = 8106 kPa
-  | volume      = 790 L
+  | volume      = 250 L
   | createdwith = [[Hydraulic Pipe Bender]]
   | cost        = 10g [[Iron]], 2g [[Gold]], 5g [[Copper]]
@@ Line 14: / Line 14: @@
 ==Notes==
-* Internal tank volume is 790 Liters, the same as the large [[Portable Tank]].
+* Internal tank volume is 250 Liters.
 * The power usage is 37.5W/s meaning a Small Battery will last 16 minutes.
 * It will add heat by a rate of 12.5J/s while powered.
 * You can insert two filters of the same type to double the speed.

← Older revision		Revision as of 11:30, 7 January 2018
Line 15:		Line 15:
	* Internal tank volume is 790 Liters		* Internal tank volume is 790 Liters
	* The power usage is 37.5W/s meaning a Small Battery will last 16 minutes.		* The power usage is 37.5W/s meaning a Small Battery will last 16 minutes.
		+	* It will add heat by a rate of 12.5J/s while powered.