FuzzyBot: Updating to match new version of source page

2017-12-26T05:31:45Z

Updating to match new version of source page

FuzzyBot: Updating to match new version of source page

2017-12-21T12:41:56Z

Updating to match new version of source page

New page

<languages />
== Summary ==
Getting the basic structure for your base is usually the one of the first things you do. You will need a base to install your solar panels, [[solid fuel generator]] and get the [[battery charger]] hooked up to an [[Power Control|APC]] to get power from the [[solar panels]]. You need frames to attach these [[:Category:Structures|structures]] too.

=== What you need ===
* [[Iron Frames]]
* [[Iron Sheets]]
* [[Welder]]
* [[Wrench]]
* [[Angle Grinder]]

=== Iron Frames ===
[[Iron Frames]] are your basic building blocks. [[Iron walls]] can be used but they don't allow [[structures]] to be placed. Iron frames do not have to have iron sheets added on them to place structures. You can use the frame itself. The frame without sheets allows you to walk through it and place [[Cables|cables]] and [[Pipes|pipes]] inside. Which you can seal up after to pass connections through rooms.

<gallery>
Iron frames.jpg|Iron Frames
Iron frames state 1.jpg|Placed
Iron frames state 2.jpg|One sheet added
Iron frames done.jpg| Second sheet added completed
</gallery>

== Constructing ==
Grab [[Iron Frames|Iron Frames]] into active hand, use right-click to bring up place mode and left-click when frame is in desired spot.

Then equip a welder in one hand and [[Iron Sheets]] in the other hand, two per frame you wish to install. The welder needs to be the active hand.

Use the 'O' button to toggle the welder on.

[[File:Welder on.jpg|300px]]

Then aim at the frame of the [[Iron Frames]] and left click. The welder will go through a green progress bar adding one [[Iron Sheets|Iron Sheet]] from the inactive hand.

[[File:Iron frames constuct.jpg|300px|Left-Click to start Welding]]
[[File:Iron frames welding.jpg|300px|Welding Progress]]

That completes one wall/ceiling/floor that you can place structures on.

== Deconstructing ==
The frame is broken down in stages. First you remove the sheets using a [[wrench]] and then the [[Angle Grinder|angle grinder]] to take down the actual frame once all sheets are removed.

It is often needed to remove one layer of [[Iron Sheets]] so you can pass new cables through a wall. In which case on [[wrench]] is needed.

← Older revision		Revision as of 05:31, 26 December 2017
Line 1:		Line 1:
		+	[[Category:Tutorials]]
	<languages />		<languages />
	== Summary ==		== Summary ==

Constructing and Deconstructing Walls/en - Revision history

FuzzyBot: Updating to match new version of source page

FuzzyBot: Updating to match new version of source page